Wolf Tooth Locked-In Bar Ends

Wolf Tooth Locked-In Bar Ends give riders more control with reduced fatigue for gravity riding
A firm, ergonomic outboard flange supports the rider's hand allowing for a lighter grip on the bars and reduced arm pump
Bar Ends extend forward and shield your hands and pinky fingers from tree strikes
Chamfered leading edge that shrugs off, rather than catching, obstacles that might take you down
Patent-Pending lobed interface prevents the bar ends from rotating within the handlebar
Compatibility:
- Compatible with most carbon and aluminum handlebars with an 18.0mm or wider internal diameter
- Use of the Locked-In Bar Ends requires a grip with an open end. Many grips with closed ends can still be made to work by punching out the closed end
- Some grips may have a removable bar end but still have a small lip on the plastic liner that keeps the grip from being able to be pushed inboard from the end of the bar [Ergon GA2, GDH]. Wolf Tooth recommends removing this lip by sanding it off using a Dremel tool
- What grips don't work:
  - Grips with angled ends [Ergon GE1 Evo]
  - We don’t suggest using grips with outboard lock on clamps, especially if the outboard clamp is an integrated bar end [Chromag Squarewave]
- Designed in collaboration with World Cup downhill athlete Joe Breeden
- Material: Rubber, 6061-T6 aluminum
- Dimensions: 101.6 mm x 76.2 mm x 38.1 mm
- Tool required: 4 mm Hex Wrench | Torque 3 Nm

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.